Hello All.

 

I did an online chat with someone named Eric earlier today and he was helpful, but I need additional assistance. I asked him if I could do the following, and he said yes, but I can't figure out how to do it.

 

Essentially I'm dynamically going to specify on page load the height and width of the wysiwyg editor area. The dimensions will vary anywhere from 35px wide to 700px wide. Realistically the thinnest area will probably be about 75px.

 

The editors other functions seem perfect for what I'm doing, but when the editor finally loads the wysiwyg area stretches from 100px (if set by my code) to about 400px.

 

I don't care if the entire control stretches to accommodate the toolbar area, if it can't be independently sized, but I can not allow a user to modify anything outside of the 100px wide boundary.

 

Example of what I get, and example of what I'd be ok with (bad ms paint job) below.

 

Thanks all. If I can get this working then I'll purchase the product straight away.

 

 

Would be ok with below: The spray can is just an uneditable area, the redish area is where i need the users to edit.